Consultancy, prototypes and series parts

For more than 50 years Sass-metal manufactures drawing, deep drawing and bending parts especially for the rubber processing industry. After the experience gained we support at an early stage of development very strictly to our clients in the development and improvement of rubber-metal parts. With the help of in-house design (SolidWorks) the designs can be quickly implemented in tools and prototypes in our own tool. Already in this phase is taken by using a robust quality to mass production techniques. For series production will be built depending on the part geometry insertion progressive or transfer dies. In the part surface (oiled, washed or provided with corrosion protection) take note of the special requirements of vulcanization.

As the base material cold and hot bands are used in the thickness range between 1 and 5 mm. To meet the need for lighter components, we also process steel up to 600 N / mm ².

Articles of our production, please refer to:
Air springs,
Metal rubber elements
Vibration elements,
Hydrobearings,
Chassis suspensions,
Motor bearings and
Machinery bearings.

Our range includes:
Butted and clinched rings as a substitute for pipe sections,
Support rings,
Reinforcement rings,
Pole plates and flywheels for the electrical industry and
Fußkufen for the furniture industry

The initial sampling and ensuring the quality in series production takes place according to the established in the automotive industry standards. We are certified to ISO 9000:2008.

We look forward to your inquiry.