Deformation of cold rolled strips with press:
In the field of classical stamping production is possible on eccentric presses from 40 to 250 tons, as well as hydraulic presses up to 250 tons. The product size ranges up to about 500 mm in length and 4 mm in thickness.

Fine blanking:
Fine blanking is a special technology or so-called punching "without air" between the Schneidematrize and the knives (0,5 - 1,0%). This method is especially useful for highly sophisticated products in question, which are dentate different. The maximum length is about 500 mm, and the maximum width of 6 mm. This allows the tolerance of + / - 0.01 mm, a uniformity of the cut edge and the clipping with minimal needle on the edge.

Drawing and deep drawing:
Deep drawing is a mode of production, with the preparing various hollow shapes such as rivets, drawing dies, industrial electric parts and the like. The diameter ratio to the length is up to 1:2.5. Of course, these products have a smaller extent, forExample up to 20 mm.

Screws:
TKG doo manufactures screws of the small range in diameter from 2 to 6 mm and using the most advanced technology of cold deformation, which has displaced pivot screws in the world due to their cost-effectiveness.

TKG provides doo screws forth in accordance with the ISO and DIN standards. We also produce special screws design according to the plans and patterns in collaboration with technologists and designers of customers. Screws can be thermally edit and galvanically protect, depending on the location and type of operation.